Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2017 >> Forte EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Electric Stability Program Diagnosis) >> DTC C1604-04: ECU Hardware Error >> DTC Inspection >> Monitor KDS/GDS Data

Monitor KDS/GDS Data

WARNING: This page is about a different car, the 2018 Kia Forte5 and 2018 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF"
  2. Connect KDS/GDS to Data Link Connector (DLC).
  3. Ignition "ON" & Engine "ON"
  4. Monitor "Battery Positive Voltage" parameter in "Current Data" with GDS/KDS.

    Specification:  B+

    Fig 1: Scantool Display - ABS/ESC System Battery Voltage During Engine ON
    G12160300Courtesy of KIA MOTORS AMERICA, INC.
  5. Is the displayed parameter within specification?

    YES 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals