| Case 1 |
DTC Strategy |
|
- Throttle blade stuck
- Open in ETC motor circuit
- Faulty ETC motor
- Faulty PCM
|
| Enable Conditions |
|
| Threshold Value |
- Throttle position greater than Limp-home position +3%
|
| Diagnostic Time |
|
| MIL ON Condition |
|
| Case 2 |
DTC Strategy |
- Abnormal TPS re-adaptation value
|
| Enable Conditions |
- During TPS adaptation (throttle is made to approach the lower mech. throttle limit stop via ramp) Learned value already saved
|
| Threshold Value |
- Throttle position 1 voltage at the lower limit stop less than 0.21V or throttle position 2 voltage at the lower limit stop greater than 4.84V or throttle position 1 and 2 voltage sum = 5V
|
| Diagnostic Time |
|
| MIL ON Condition |
|
| Case 3 |
DTC Strategy |
- Abnormal TPS re-adaptation value
|
| Enable Conditions |
- Delta Limphome (last drive cycle adaptation - current dive cycle adaptation) or ETC replaced or PCM reset
|
| Threshold Value |
- Throttle position 1 voltage at the lower stop limit + offset greater than 0.695V
- Throttle position 2 voltage at the lower stop limit - offset (0.025V) less than 4.305V
|
| Diagnostic Time |
|
| MIL ON Condition |
|
| Case 4 |
DTC Strategy |
- TPS re-adaptation has failed due to corrupted input conditions
|
| Enable Conditions |
|
| Threshold Value |
- Engine speed greater than 250 RPM
- Vehicle speed greater than 0 mph
- Accelerator pedal greater than 14.9%
- ECT less than 5.3°C (41.54°F)
- ECT greater than 100.5°C (212.9°F)
- IAT less than 5.3°C (41.54°F)
|
| Diagnostic Time |
|
| MIL ON Condition |
|
| Case 5 |
DTC Strategy |
- TPS re-adaptation has failed due to corrupted input conditions
|
| Enable Conditions |
|
| Threshold Value |
- Engine speed greater than 250 RPM
- Vehicle speed greater than 0 mph
- Accelerator pedal greater than 14.9%
- ECT less than 5.3°C (41.54°F)
- ECT greater than 100.5°C (212.9°F)
- IAT less than 5.3°C (41.54°F)
|
| Diagnostic Time |
|
| MIL ON Condition |
|
| Case 6 |
DTC Strategy |
- TPS adaptation fault or abnormal value during first initialization
|
| Enable Conditions |
- First initialization
- Ignition ON
|
| Threshold Value |
- Learning stop due to corrupted input condition and UMA learning error
|
| Diagnostic Time |
|
| MIL ON Condition |
|
| Case 7 |
DTC Strategy |
|
| Enable Conditions |
|
| Threshold Value |
- Learning stop due to corrupted input condition and UMA learning error
|
| Diagnostic Time |
|
| MIL ON Condition |
|