Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules & Clock Spring >> Passenger Airbag (PAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.
  3. Place a passenger airbag on the crash pad and tighten the passenger airbag (A) mounting bolts.
    G11953747Courtesy of
  4. Install the crash pad.

    (Refer to "MAIN CRASH PAD ASSEMBLY .")

  5. Connect the passenger airbag connector (B).
    G11953748Courtesy of
  6. Tighten the passenger airbag mounting bolts (A).

    Tightening torque: 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

  7. Reinstall the glove box housing.

    (Refer to "GLOVE BOX HOUSING .")

  8. Reconnect the battery negative cable.
  9. After installing the passenger airbag (PAB), confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals