Component Inspection
- IG Key "OFF".
- Disconnect HECU connector.
- Measure resistance between Pin No. 1 (Signal) terminal and Pin No. 2 (Power) terminal of the Rear LH Wheel Speed Sensor. (Component Side)
Specification: Approx. 3.899 MΩ
- Is the resistance of Rear LH wheel speed sensor similar as shown above?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace wheel speed sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.