Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Soul ! >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Control System - 1.6L) >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line (refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE .")
  3. Remove the Alternator.

    (Refer to "ALTERNATOR .")

  4. Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
G11950114Courtesy of
scientia non olet · About Mike's Workshop Manuals