Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Sorento L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Engine Control System - 3.3L) >> Engine Coolant Temperature Sensor (ECTS) >> Repair Procedure >> Removal

Repair Procedure: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Remove the air cleaner assembly.

    (Refer to "AIR CLEANER ASSEMBLY ")

  3. Disconnect the engine coolant temperature sensor connector (A).
  4. Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.
    CAUTION:
    • Note that engine coolant may flow out from the water temperature control assembly when removing the sensor.
    Fig 1: Locate Engine Coolant Temperature Sensor Connector And Spring Clip
    G11872124Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals