DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
DTC Strategy	Case 1	O2 sensor Controller Malfunction Monitoring	Poor Connector Connection Unstable Power Defected PCM
	Case 2	Knock Acquisition check
	Case 3	Fuel injector driver boost voltage check
	Case 4	Powerstage Port Flap Driver over temperature
	Case 5	H-bridge (ETC, Port Flap, wastegate) malfunction (ATIC111)
	Case 6	Output driver malfunction (ATIC140)
	Case 7	Power Relay driver malfunction (ATIC139)
	Case 8	5V power supply driver malfunction (ATIC139)
Enable Condition	Case 1	Ignition Switch "ON" Battery voltage is greater than 10V and less than 16V
	Case 2	Enigne speed is greater than 32rpm
	Case 3	Enigne speed is greater than 32rpm Time delay after "Engine Running" elapsed is greater than 0.3 sec.
	Case 4	Enigne speed is greater than 32rpm Battery voltage is greater than 10V and less than 16V
	Case 5~8	Ignition Switch "ON"
Threshold Value	Case 2	200 Rev.
	Case 3	3 sec.
	Case 4	0.4 sec.
	Case 5~8	1 sec.
MIL ON Condition		2 Driving Cycles