Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Sedona LX >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Supplemental Restraint System Control Module (SRSCM) And Sensors) >> Occupant Detection System (ODS) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ODS equipped seat cushion assembly. (Refer to FRONT SEAT ASSEMBLY )
  2. Install the front passenger seat assembly.

    (Refer to FRONT SEAT ASSEMBLY )

  3. Reconnect the battery negative cable.
  4. After installing the ODS, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the ODS does not require suppression and the passenger airbag is enabled.
scientia non olet · About Mike's Workshop Manuals