Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Sedona EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Adaptive Front Lighting System) >> Vehicle Height Sensor (VLS) >> Repair Procedures >> Removal >> Notes

Repair Procedures: Removal: Notes

WARNING: This page is about a different car, the 2016 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the vehicle height sensor connector (A) and linkage (B).
    Fig 1: Locating Vehicle Height Sensor Connector And Linkage
    G11801497Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the front/rear wheel vehicle height sensor (A) after loosening the mounting bolt.

    [Front Wheel] 

    Fig 2: Locating Front Wheel Vehicle Height Sensor
    G11801498Courtesy of KIA MOTORS AMERICA, INC.

    [Rear Wheel] 

    Fig 3: Locating Rear Wheel Vehicle Height Sensor
    G11801499Courtesy of KIA MOTORS AMERICA, INC.
  4. If the air suspension is installed, remove the vehicle height sensor.

    (Vehicle height sensor of the general suspension vehicle count: 2EA)

scientia non olet · About Mike's Workshop Manuals