ECM Neutral Mode Procedure (With Smart key)

WARNING: This page is about a different variant/trim than selected.

After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM Neutral Mode" procedure using KDS/GDS.
  (Refer to REPAIR PROCEDURES "Body Electrical System - "Smart key System )
2. After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
  (Refer to REPAIR PROCEDURES "Body Electrical System - "Smart key System "")
  
  [If installing a new ECM]
  
  Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
  
  (Refer to REPAIR PROCEDURES "Body Electrical System - "Smart key System "")