Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Optima LX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Body Control Module (BCM) Diagnosis (HEV)) >> DTC B1602: CAN Error >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

WARNING: This page is about a different variant/trim than selected.
  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erase DTC, keep the vehicle condition within "the enable conditions"(Refer to DTC Detecting Condition  table.)
    Fig 1: Display - CAN Error Screen
    G11820174Courtesy of KIA MOTORS AMERICA, INC.
  5. Is the same DTC occurred again?

    YES 

    • Proceed to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the BCM's connector or was repaired and BCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then proceed to "Verification Of Vehicle Repair " procedure.
scientia non olet · About Mike's Workshop Manuals