Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Optima EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Electronic Stability Control (ESC) System (HEV)) >> Front Wheel Speed Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front wheel and tire.

    Tightening torque: 

    88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

  2. Remove the front wheel speed sensor mounting bolt (A).

    Tightening torque: 

    6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

    Fig 1: Removing Front Wheel Speed Sensor Mounting Bolt
    G11816813Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the front wheel guard.
  4. Remove the front wheel speed sensor cable mounting bolt.
  5. Disconnect the front wheel speed sensor connector, then remove the front wheel speed sensor.
  6. Installation is the reverse of removal.
scientia non olet · About Mike's Workshop Manuals