Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
Clutch pressure sensor installation:

11 ~ 15 N.m (1.1 ~ 1.5 kgf.m, 8.0 ~ 11.1 lb-ft)

NOTE: When installing, apply the ATF oil to the O-ring (A).

Fig 1: Locating O-Ring
Courtesy of KIA MOTORS AMERICA, INC.
Perform the clutch pressure sensor calibration. (Refer to "Clutch Pressure Sensor Calibration .")