Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2016 >> Cadenza Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control (ESC) System Diagnosis >> DTC C1647: CAN Hardware Error - Sensor Channel >> DTC Inspection >> Monitor DTC Status

Monitor DTC Status

  1. Connect GDS and select "Diagnostic Trouble Codes (DTC)  " mode.
  2. Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
  3. Read "DTC Status" parameter in DTC menu of the GDS.
    Fig 1: Screen Display - DTC Status Parameter
    G11787606Courtesy of KIA MOTORS AMERICA, INC.
  4. Is parameter displayed "History (Not Present) fault"?

    YES 

    • Fault is intermittent caused by poor connection and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Go to next step.
scientia non olet · About Mike's Workshop Manuals