Cluster Replacement

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the center fascia lower panel (A).

Fig 1: Removing Center Fascia Lower Panel Using Screwdriver Or Remover
Courtesy of KIA MOTORS AMERICA, INC.
Remove the in-car hose (A).
Disconnect the A/C & heater controller unit connectors (B) from the center fascia lower panel.

Fig 2: Locating In-Car Hose Or A/C & Heater Controller Unit Connectors
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the crash pad garnish [RH] (A).

Fig 3: Removing Crash Pad Garnish Using Screwdriver Or Remover (RH)
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the crash pad center garnish (A).

Fig 4: Removing Crash Pad Center Garnish Using Screwdriver Or Remover
Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the crash pad side cover (A).
[LH]

Fig 5: Removing Crash Pad Side Cover Using Screwdriver Or Remover (LH)
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screw, then remove the crash pad garnish [LH] (A).

Fig 6: Locating Crash Pad Garnish With Mounting Screw (LH)
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screw, then remove the cluster fascia panel (A).

Fig 7: Locating Cluster Fascia Panel With Mounting Screw
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws, then remove the cluster assembly (A).

Fig 8: Locating Cluster Assembly With Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Fig 9: Locating Cluster Connector
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.