Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2015 >> Soul EV Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) & Sensors >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation

Repair Procedures: Installation

CAUTION:
  • Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.
  1. Install the new front impact sensor.
  2. Tighten the front impact sensor (B) mounting bolt.

    Tightening torque: 

    7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)

    Fig 1: Front Impact Sensor, Connector And Mounting Bolt
    G10727156Courtesy of KIA MOTORS AMERICA, INC.
  3. Connect the front impact sensor connector (A).
  4. Reconnect the battery negative cable.
  5. After installing the Front Impact Sensor, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals