Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2015 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Supplemental Restrain System Control Module (SRSCM) & Sensors) >> Side Impact Sensor (SIS) >> Repair Procedures >> Removal >> Pressure Side Impact Sensor

Pressure Side Impact Sensor

WARNING: This page is about a different car, the 2016 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Removal of the airbag must be performed according to the precautions/procedures described previously.
  • Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
  • Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.
  1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning to work.
  2. Remove the front door trim.

    (Refer to Body - "FRONT DOOR TRIM ")

  3. Disconnect the pressure side impact sensor connector (A) and remove the pressure side impact sensor mounting screws (B).
    Fig 1: Locate Pressure Side Impact Sensor
    G11933786Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals