Ground Circuit Inspection
- Ignition "OFF" & Disconnect Power Steering Pressure Sensor connector.
- Ignition "ON".
- Measure voltage between Pin No. 3 (Power) terminal of Power Steering Pressure Sensor harness connector and chassis ground. (A)
- Measure voltage between Pin No. 3 (Power) terminal and Pin No. 1 (Ground) terminal of the Power Steering Pressure Sensor. (B)
Specification: "A" - "B" = 200mV0| |
- Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "Verification Of Vehicle Repair " procedure.