Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2015 >> Optima EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 56 (Supplemental Restraint System Control Module (SRSCM) & Sensors - Optima HEV) >> Seat Track Position Sensor (STPS) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Be sure to install the harness wires not to be pinched or interfered with other parts.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  3. Install the STPS with two screws.
  4. Install the front seat assembly. (Refer to SEAT ASSEMBLY REPLACEMENT )
  5. Reconnect the battery negative cable.
  6. After installing the Seat Track Position Sensor, confirm proper system operation:

    Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.

scientia non olet · About Mike's Workshop Manuals