Monitor GDS Data
- Check DTC
- Check DTC with GDS.
- Check DTC related CAN communication is set on SMK unit and every modules.
- If there is DTC related Module Check the DTC according to troubleshooting guide.
- Repair and erase the DTC with GDS.
- Is the DTC erased?
YES
- Check poor connection between harness connector and SMK unit or ECM: Thoroughly check the looseness, poor connection, bent, corrosion, contamination, deformation or damage of connector.
Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to next procedure.
- Check poor connection between harness connector and SMK unit or ECM: Thoroughly check the looseness, poor connection, bent, corrosion, contamination, deformation or damage of connector.