Repair procedures: Installation
WARNING: This page is about a different variant/trim than selected.
- Installation is reverse of removal.
NOTE:
- Be careful not to damage other hose by when tightening the clamp.
- Install the clamp in the specified direction to prevent interference with surrounding components.
- Refill the hybrid motor cooling system with coolant and then perform the air bleeding using the GDS. (Refer to "COOLANT ")
- Perform the resolver calibration using the GDS. (Refer to "Resolver Calibration ")
- Perform the clutch pressure sensor calibration using the GDS. (Refer to "CLUTCH PRESSURE SENSOR CALIBRATION ")
- Confirm the coolant leak or fluid leak from the hose connections part in state of engine start.