Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2014 >> Optima EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Control System - 2.0L - Optima) >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2015 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line. Refer to RELEASE RESIDUAL PRESSURE IN FUEL LINE .
    CAUTION: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the intake manifold. Refer to INTAKE AND EXHAUST SYSTEM .
  4. Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Fig 1: Rail Pressure Sensor & Connector
G07379750Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals