Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2014 >> Forte EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Control System - 1.8L) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the resonator and the air intake hose (Refer to "INTAKE & EXHAUST SYSTEM ").
  3. Disconnect the ETC module connector (A).
    Fig 1: ETC Module Connector
    G09748730Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the coolant hoses (B).
  5. Remove the installation bolts (C), and then remove the ETC module from the engine.
    Fig 2: Coolant Hoses & Installation Bolts
    G09748731Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals