Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System - 2.0L) >> Knock Sensor (KS) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the knock sensor connector (A).
    Fig 1: Identifying Knock Sensor Connector
    G08331055Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the intake manifold (Refer to REMOVAL AND INSTALLATION .
  4. Remove the installation bolt (A), and then remove the sensor from the cylinder block.
    Fig 2: Knock Sensor Component Location
    G08331056Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals