Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Control System - 2.4L) >> Crankshaft Position Sensor (CKPS) >> Repair Procedure >> Installation

Repair Procedure: Installation

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
CAUTION:
  • Apply the engine oil to the O-ring.
CAUTION:
  • Insert the sensor in the installation hole and be careful not to damage when installation.
  1. Installation is reverse of removal.

Crankshaft position sensor installation bolt:  9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Crankshaft position sensor protector installation bolt (M8):  18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)

Crankshaft position sensor protector installation bolt (M6):  9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

scientia non olet · About Mike's Workshop Manuals