Repair Procedures: Installation
WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable and wait for at least three minutes.
- Install a Curtain Airbag (CAB) on the mounting bracket.
- Tighten the CAB mounting bolts and nuts.
Tightening torque:
1.1 ~ 1.5 kgf.m (10.8 ~ 14.7 N.m, 8.0 ~ 10.8 lb.ft)
CAUTION:- Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
- Connect the CAB connector.
- Install the following parts. (Refer to
INTERIOR
)
- Roof trim, Rear pillar trim
- Luggage side trim, Rear seat
- Reconnect the battery negative cable.
- After installing the Curtain Airbag (CAB), confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.