Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Supplemental Restraint System (SRS) Control Module & Sensors) >> Seat Track Position Sensor (STPS) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Ensure that the harness is installed and routed properly to prevent damage to the wiring.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Remove the ignition key from the vehicle.
  3. Install the STPS with two screws.
  4. Install the front seat assembly. (Refer to FRONT SEAT )
  5. Reconnect the battery negative cable.
  6. After installing the Seat Track Position Sensor, confirm proper system operation:

    Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.

scientia non olet · About Mike's Workshop Manuals