Operating Modes - Rain Sensing Windshield Wiper System: Notes
WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.
MULTIFUNCTION SWITCH POSITION
| Multifunction switch position | Rain sensor operating mode | Sensor action |
|---|---|---|
| MIST | MIST | Mist is controlled by the column switch. The sensor has no affect on this function |
| OFF | OFF | If not already parked, wiper motor runs in low speed until blades are in the depressed park position. |
| AUTOMATIC Automatic mode has 5 SENSITIVITY settings. This is further defined in par 84. |
AUTOMATIC | AUTOMATIC Automatic INT/speed control. The sensitivity to raindrop accumulation on the windshield is set by the MULTIFUNCTION SWITCH sensitivity adjustment. |
| LOW SPEED | MANUAL | Wiper motor runs continuously in low speed, for example 45 wipes/minute. The sensor has no affect on this function |
| HI SPEED | MANUAL | Wiper motor runs continuously in high speed, for example 60 wipes/minute. The sensor has no affect on this function |
| WASH - DEMAND WASHER SW ≥ 0.6 SEC |
WASH | If washer sw on after 0.6 sec then wipes during 2.5 to 3.8 sec. The rain sensor enables the wipers and controls the after wipes. |
| WASH - DEMAND WASHER SW < 0.6 SEC |
WASH | If washer sw on less than 0.2 to 0.6 sec then once wipes |