Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Windshield Wiper System & Washer System) >> Front Washer Motor >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • When servicing the washer pump, be careful not to damage the washer pump seal.
  • Do not operate the washer pump before filling the washer reservoir.

    Failure to do so could result in premature pump failure.

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front bumper cover. (Refer to FRONT BUMPER )
  3. Remove the washer hose and the washer motor connector (A).
    Fig 1: Identifying Washer Motor Connector
    G06861784Courtesy of HYUNDAI MOTOR CO.
  4. Disconnect the washer fluid level sensor switch connector (A).
    Fig 2: Identifying Washer Fluid Level Sensor Switch Connector
    G06861785Courtesy of HYUNDAI MOTOR CO.
  5. Remove the washer reservoir after removing 3 bolts.
    Fig 3: Identifying Washer Reservoir
    G06861786Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About Mike's Workshop Manuals