Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2012 >> Soul Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Supplemental Restraint System (SRS) Control Module & Sensors) >> Front Impact Sensor (FIS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Removal of the airbag must be performed according to the precautions/procedures described previously.
  • Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Disconnect the Front Impact Sensor connector.
  3. Remove the Front Impact Sensor mounting bolt.
    Fig 1: Identifying Front Impact Sensor
    G06857574Courtesy of HYUNDAI MOTOR CO.
  4. Remove the Front Impact Sensor.
scientia non olet · About Mike's Workshop Manuals