Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2012 >> Sedona EX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 3) >> DTC P0263: Cylinder 1 Contribution/Balance >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

  1. Connect GDS to Data Link Connector (DLC).
  2. IG "ON".
  3. Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.
  4. Read "DTC Status" parameter.
    5. Fig 1: Screen Display - DTC Status Parameter
    G00520227Courtesy of KIA MOTORS AMERICA, INC.
  5. Is parameter displayed "Present fault"?

    YES 

    • Go to SYSTEM INSPECTION  procedure.

      • NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to VERIFICATION OF VEHICLE REPAIR  procedure.
scientia non olet · About Mike's Workshop Manuals