Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2012 >> Optima LX, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 79 (Engine Control System - 2.0L) >> Electric WGT Control Actuator >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the EWGA connector (A).
    Fig 1: EWGA Connector
    G07379794Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the shaft link assembly (B) after removing the C-ring (A).
    Fig 2: Shaft Link Assembly & C-Ring
    G07379795Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the EWGA after removing the bolts (A).
    Fig 3: EWGA Bolts
    G07379796Courtesy of KIA MOTORS AMERICA, INC.
    CAUTION: When carrying the turbo charger, do not hold the rod of the turbo charge to prevent bending the rod.
scientia non olet · About Mike's Workshop Manuals