Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2012 >> Optima LX, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 79 (Engine Control System - 2.0L) >> Crankshaft Position Sensor (CKPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the crankshaft position sensor connector (A).
    Fig 1: Crankshaft Position Sensor Connector
    G07379729Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the protector (A).
    Fig 2: Crankshaft Position Sensor Protector
    G07379730Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the installation bolt (A), and then remove the crankshaft position sensor.
Fig 3: Crankshaft Position Sensor Component Location And Installation Bolt
G07379731Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals