Monitor Scantool Data
WARNING: This page is about a different variant/trim than selected.
- Check DTC
- Check DTC with scantool.
- Check DTC related CAN communication is set on Smartkey Module and every modules.
- If there is DTC related Module Check the DTC according to troubleshooting guide.
- Repair and erase the DTC with Scantool.
- Is the DTC erased?
YES
- Check poor connection at each module communicates through CAN Line.
: Thoroughly check the looseness, poor connection, bent, corrosion, contamination, deformation or damage of connector. Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to next procedure.
- Check poor connection at each module communicates through CAN Line.