Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2012 >> Optima LX, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Control System - HEV) >> Crankshaft Position Sensor (CKPS) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the crankshaft position sensor connector (A).
    Fig 1: Identifying Crankshaft Position Sensor Connector
    G08312852Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the protector (A).
    Fig 2: Identifying Protector And Mounting Bolts
    G08312853Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the installation bolt (A), and then remove the crankshaft position sensor.
    Fig 3: Crankshaft Position Sensor Component Location
    G08312854Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals