Signal Circuit Inspection

■ Check signal circuit voltage 

1. IG key OFF.
2. Disconnect 'CRUISE REMOCON SWITCH' connector.
3. IG key ON.
4. Measure voltage between 'Signal (Cruise sw)' terminal of 'CRUISE REMOCON SWITCH' harness connector and chassis ground.

   Specification :  4.8V~5.1V

   For 2012

   Fig 1: Measuring Voltage Between 'Signal (Cruise Sw)' Terminal Of 'Cruise Remocon Switch' Harness Connector & Chassis Ground

   Courtesy of KIA MOTORS AMERICA, INC.

   For 2013 refer to ETM 

5. Is the measured value within specification?

   YES 

   • Go to "COMPONENT INSPECTION " procedure.

   NO 

   • Go to Check Short In Signal Circuit .