Power Circuit Inspection

■ Check power circuit voltage 

1. IG key OFF.
2. Disconnect 'CRUISE REMOCON SWITCH' connector.
3. IG key ON.
4. Measure voltage between 'CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' harness connector and chassis ground.

   Specification :  11.5V~13.0V

   For 2012

   Fig 1: Measuring Voltage Between 'Cruise Main' Terminal Of 'Cruise Remocon Switch' Harness Connector & Chassis Ground

   Courtesy of KIA MOTORS AMERICA, INC.

   For 2013 refer to ETM 

5. Is the measured value within specification?

   YES 

   • Go to "SIGNAL CIRCUIT INSPECTION ".

   NO 

   • Repair short to ground/open between 'CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Cruise supply' terminal of PCM harness connector, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.