GDS Data Analysis
- IG "ON".
- Connect GDS to Data Link Connector. (DLC)
- Start and drive vehicle in gear and maintain vehicle speed at or above 10km/h. (6.2mph).
- Monitor the "WHEEL SPEED SENSOR" parameter on the Current Data menu of the GDS.
- Is parameter displayed within specifications ?
Specification :
Compare with other parameters related to wheel speed sensor
If it is the same as other parameters, it is in normal condition
YES
Fault is intermittent caused by poor connection in wheel speed sensor harness (FL) and/or HECU's connector or was repaired and HECU memory was not cleared.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Repair or replace as necessary and then go to VERIFICATION OF VEHICLE REPAIR procedure.
NO
Go to next step.