Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2012 >> Optima LX, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Seats >> Body Control - Power Seat Module Diagnosis - Except HEV >> DTC B1602: CAN Error >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erasing DTC, keep the vehicle condition within "the enable conditions" Refer to DTC DETECTING CONDITION  table.
    Fig 1: Scantool Display - DTC (CAN ERROR)
    G07384575Courtesy of KIA MOTORS AMERICA, INC.
  5. Is the same DTC occurred again?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the PSM's connector or was repaired and PSM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to VERIFICATION OF VEHICLE REPAIR  procedure.
scientia non olet · About Mike's Workshop Manuals