Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2011 >> Sorento Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Immobilizer System) >> Immobilizer Control Unit >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2011 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel.

    (Refer to the "CRASH PAD ")

  3. Remove the steering column assembly.

    (Refer to the "STEERING COLUMN AND SHAFT ")

  4. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening a shear bolt (B).
    Fig 1: Identifying SMARTRA Unit And Shear Bolt
    G06873828Courtesy of HYUNDAI MOTOR CO.
    NOTE: When remove the shear bolt (B), make a groove on head of the shear bolt by using a punch.
scientia non olet · About Mike's Workshop Manuals