Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2011 >> Rio Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transaxle System Diagnosis) >> DTC P0707: Transaxle Range Switch Circuit Low Input >> General Information >> DTC Detecting Condition

General Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Check for No signal
  • Open or short in circuit
  • Faulty Shift cable adjustment
  • Faulty Inhibitor switch and Manual control lever position adjustment
  • Faulty TRANSAXLE RANGE SWITCH
  • Faulty TCM (PCM)
Enable Conditions
  • Ne ≥ 500rpm
  • Battery voltage ≥ 9V
  
Threshold Value
  • No signal detected
Diagnostic Time
  • More than 30sec
Fail Safe
  • Recognition as previous signal
    • When P-D or R-D or D-R SHIFT is detected, it is regarded as N-D or N-R though "N" signal is not detected.
    • When sports mode S/W is ON without P, R, N, D-RANGE signals, it is regarded sports mode. (DTC is not set)
scientia non olet · About Mike's Workshop Manuals