Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2009 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control Module (Air Bag) >> Troubleshooting >> Description >> Clear The DTC And Check The Vehicle Again

Clear The DTC And Check The Vehicle Again

  1. Install the DAB module and connect the DAB connector.
  2. Connect the connector of the PAB, CAB, BPT, FIS and SIS.
  3. Connect the SRSCM connector.
  4. Connect the battery negative cable to the battery.
  5. Connect a Hi-Scan (Pro) to the data link connector.
  6. Turn the ignition switch to ON.
  7. Clear the DTC stored in the SRSCM memory with the Hi-Scan (Pro)
  8. Turn the ignition switch to LOCK and wait for at least 30 seconds.
  9. Turn the ignition switch to ON and wait for at least 30 seconds.
  10. Check the vehicle again with the Hi-Scan (Pro) .

    Does the above DTC(s) go off?

    YES 

    • Problem is intermittent or was repaired and SRSCM memory was not cleared.

    NO 

    • Replace the SRSCM with a new one and then check the vehicle again. At this time, if the vehicle normally operates with a new one, the fault may be the SRSCM. Replace the SRSCM.
scientia non olet · About Mike's Workshop Manuals