Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2009 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Module >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Tighten the CAB mounting bolts (6EA) and nut (1EA).

    Tightening torque

    : 0.8 ~ 1.2 kgf.m (7.8 ~ 11.8 Nm, 5.8 ~ 8.7 lb.ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  4. Connect the CAB connector.
  5. Install the following parts. (Refer to INTERIOR )
    1. Side trim, Roof trim
  6. Reconnect the battery negative cable.
  7. After installing the Curtain Airbag (CAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals