Signal Circuit Inspection

Ignition "ON" & Engine "OFF" & ESC Switch "ON".
Measure voltage between terminal "31" of the HECU harness connector and chassis ground.
Specification: Approx B+

Fig 1: Measuring Voltage Between Terminal "31" Of HECU Harness Connector And Chassis Ground
Courtesy of KIA MOTORS AMERICA, INC.
Is the measured voltage within specifications?
YES
- Go to "COMPONENT INSPECTION " Procedure.
NO
- Check for damaged harness and poor connection in the power harness between the battery terminal (+) and the terminal "31" of the HECU harness connector. Check for open or blown 10 A fuse referring to "Circuit Diagram". Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- If OK, Go to "COMPONENT INSPECTION " Procedure.