Power Circuit Inspection

Ignition "ON" & Engine "OFF".
Measure voltage between terminal "3" of the G-sensor harness connector and chassis ground.
Specification: Approx. B+

Fig 1: Measuring Voltage Between Terminal "3" Of G-sensor Harness Connector And Chassis Ground
Courtesy of KIA MOTORS AMERICA, INC.
Is the measured voltage within specifications?
YES
- Go to "SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Check for open or short in the power harness between terminal "24" of the HECU harness connector and terminal "3" of the G-sensor harness connector. Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.