Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2009 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Brakes >> Traction Control >> Esp (Electronic Stability Program) >> DTC Troubleshooting >> DTC C1201: Wheel Speed Sensor Front-LH Range / Performance / Intermittent >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Engine "ON".
  2. Connect scan tool to Data Link Connector (DLC).
  3. Start and drive vehicle in gear and maintain vehicle speed at or above 12 km/h (7.5 mph)
  4. Monitor the "Wheel Speed Sensor" parameter on the Scan Tool.

    Specification: Compare with another parameters related to wheel speed sensor. If it is the same as another parameters, it is in normal condition

    Fig 1: Monitoring Wheel Speed Sensor Parameter On Scan Tool (1 Of 2)
    G06412616Courtesy of KIA MOTORS AMERICA, INC.
    Fig 2: Wheel Speed Sensor Waveform Graph
    G06412617Courtesy of KIA MOTORS AMERICA, INC.
  5. Is parameter displayed within specifications?

    YES 

    • Fault is intermittent caused by faulty HECU or external noise, was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals