Monitor SCANTOOL Data

1. Connect scantool to Data Link Connector(DLC).
2. IGN "ON" & Engine "OFF"
3. Monitor the "ECU, KEY, Smartra Status" Parameter on the Scantool.

   Specification : 'LEARNT'

   Fig 1: View Of Current Data Display

   Courtesy of KIA MOTORS AMERICA, INC.

   Fig.1) This data show that 3 keys have been taught, ECU has been learned, Key in key cylinder has been learned and SMARTRA3 has been learned.

4. Has the "SMARTRA" status been learned?

YES 

Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, damage on the ECM or SMARTRA.

And has not erased this DTC which is not erased previous repair. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

NO 

Go to next procedure.