Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2009 >> Optima EX, 2.7 4 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Module >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Disconnect the battery negative cable and wait for at least three minutes.
  2. Remove the ignition key from the vehicle.
  3. Install a Curtain Airbag(CAB) on the mounting bracket.
  4. Tighten the CAB mounting bolts (6EA) and nuts (2EA).

    Tightening torque 

    : 1.1 ~ 1.5 kgf.m(10.9 ~ 14.7 Nm, 8.0 ~ 10.8 lb.ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  5. Connect the CAB connector.
  6. Install the following parts. (Refer to ROOF TRIM )
    1. Side trim, Roof trim
  7. Reconnect the battery negative cable.
  8. After installing the Curtain Airbag(CAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals