Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Kia >> 2009 >> Borrego Limited, RWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control Module (SRSCM) >> B1451 SIS (Side Impact Sensor) rear-Driver Circuit Short to Ground >> Main harness Circuit Inspection

Main harness Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
  3. Disconnect RDSIS connector and SRSCM main harness connector.
  4. Measure resistance between terminal "1" or "2" of the DSIS harness connector and chassis ground.

    Specification :  ∞

  5. Is the measured resistance within specifications?

    YES 

    NO 

    • Substitute the SRSCM main harness and check for proper operation.

      If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About Mike's Workshop Manuals