Power Circuit Inspection

IG "OFF"
Disconnect Main Relay
IG "ON" & ENG "OFF".
Measure the voltage between terminal 2 of main relay harness connector and chassis ground.
Measure the voltage between terminal 5 of main relay harness connector and chassis ground.
Specification : B+

Fig 1: Measuring Voltage Between Terminal 5 Of Main Relay Harness Connector And Chassis Ground
Courtesy of KIA MOTORS AMERICA, INC.
Is the measured voltage within specification ?
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check fuse between battery and main relay is disconnected.
- Repair or replace open or short in harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.